Which Mercedes-Benz do you have?
The vehicle database lists 88 Mercedes-Benz models, and parts, labour time and price all move between them. Pick yours from the list below for the detail that applies to your car rather than to the range.
Mercedes-Benz · Clutch Replacement
Slipping or juddering clutches replaced as a complete kit, not piecemeal. Priced per Mercedes-Benz model, not per brand.
Clutch Replacement on a Mercedes-Benz is the same job it is on anything else right up until it is not, and the difference is always in the parts and the tolerances rather than the procedure.
The vehicle database lists 88 Mercedes-Benz models, and parts, labour time and price all move between them. Pick yours from the list below for the detail that applies to your car rather than to the range.
Every visit includes a battery health test — not a voltage reading, a load test — because a Mercedes-Benz in Dubai is on a two-to-three year battery cycle and the cheapest time to find a failing one is while somebody is already looking at the car. On the start-stop models in this range that also means checking whether the battery has been registered, because an unregistered replacement is being charged to the wrong profile.
Clutch wear happens almost entirely during engagement, and stop-start crawling on Sheikh Zayed Road is thousands of engagements per week. A clutch that would last 150,000 km on open roads can be finished at 70,000 km on a commute made mostly of traffic.
Many modern cars use a dual-mass flywheel that has its own springs and its own wear. Fitting a new clutch to a worn dual-mass gives you a car that judders on a new clutch, and the only fix is doing the job again. We check it while the box is out and tell you the cost before reassembly, not after.
Pick your model for the price and the labour time that apply to your car.
Engine revs rising without matching acceleration in the higher gears, a burning smell after hill starts, judder as you pull away, or the biting point creeping upward toward the top of the pedal travel.
Most cars are one to two days. Front-wheel-drive cars where the subframe has to come down sit at the longer end.
If it is a dual-mass unit and it has play or noise, yes. A single-mass flywheel can usually be machined. We show you the measurement rather than asking you to take it on trust.
Call, or send your location on WhatsApp. We will tell you the price before we set off.